Water and electricity separation of hot water bag brand

How to fill the hot water bag?

1. Choose an empty bottle with water, the threads should match the funnel; national standard hot water bag manufacturer to take off the jacket mouth, revealing the water injection port, flat on the desktop.

2. with a small funnel is a slanted (or with a toothpick and other sharp objects) will be filled with water out of the plug, save the plug.

3. Spin the funnel on the empty bottle, holding the water injection side of the bag body, the funnel mouth gently inserted into the water injection port, the entire funnel neck should be inserted into it, slowly inject 800 ~ 1000ml of clean water by squeezing (to pure water is better), hot water bags manufacturer note that do not let the water overflow to the power jack.

4. Pull out the funnel, the hot water bag on a flat surface, lift the side of the water injection port, lightly press the bag body, exhaust the air, wait until there is no bubble water overflow, plug tight plug. Put the hot water bag flat, at this time the height should be about 55mm. In note: a water injection can not be changed after the water, so as not to cause the loss of thermite in the bag.

5. wipe open the hot water bag, including the water injection port side, power jack and other wet places of the hot water bag, and then completely dry before powering on.